Wheels Manufacturing Bottom Bracket Multi Adapter Kit Finally Shipping

Wheels Manufacturing Shimano and SRAM bottom bracket PFBB30 adapters and shim kits with wave washers and spacersBack in October, Wheels Manufacturing announced their BB Multi Adapter Kit, then it got pulled back to the drawing board.

Now, finally, it’s available on their website and shipping. WM’s Dave Whittingham says they lengthened the sleeve of the adapters so they’d have better contact with the bottom bracket bearings even when used with spacers between adapter and frame.

The kit has everything you’d need to fit Shimano or SRAM GXP cranksets into BB30 and PFBB30 frames using the bearings already in your frame or bottom bracket. The kit also includes a massive variety of spacers for both systems, enough adapters to do four Shimano bikes and four SRAM bikes, plus extra wave washers and a removal tool.

Retail is $200. Full list of ingredients below…

Wheels Manufacturing Shimano and SRAM bottom bracket PFBB30 adapters and shim kits with wave washers and spacers

(8) SHIMANO adapter (24mm ID, Shimano right or left; SRAM right only)
(4) SRAM-LEFT adapter (22mm ID, Shimano right or left; SRAM right only)
(4) SRAM-RIGHT adapter (24mm ID, Shimano right or left; SRAM right only)
(12) 0.7mm spacer – right (24mm ID, Shimano right or left; SRAM right only)
(4) 1.8mm spacer – right (24mm ID, Shimano right or left; SRAM right only)
(4) 2.5mm spacer – right (24mm ID, Shimano right or left; SRAM right only)
(8) 1.0mm spacer – left (30mm ID, SRAM)
(4) 2.5mm spacer – left (30mm ID, SRAM)
(4) 5mm spacer – left (30mm ID, SRAM)
(4) 10mm spacer – left (30mm ID, SRAM)
(8) Wave washer
(1) Removal tool for pulling adapter out of BB

Oh, and check out these other killer goods we spotted in their Eurobike booth!

Comments

Ed R - 12/14/12 - 1:17pm

Still no Campy? WTF!

Ben - 12/14/12 - 2:26pm

Why not just get a BB24 to BB30 from Rotor. $90 for what you need versus $200 for what you need + a lot of stuff you don’t need.

http://www.rotorbikeusa.com/products/bb30-24_bottom_bracket.html

Dan - 12/14/12 - 4:46pm

They’ve been doing Campy adapters for some time now; they’re just not included in this kit.

Virgulino - 12/15/12 - 12:39am

What about stiffness?

Mallory - 12/15/12 - 10:25am

@Ben… You do understand this kit is directed at shops …(?) You can buy any of the desired adaptors separately.

jeff - 12/16/12 - 8:21am

Does anyone make an adapter to ditch my EBB and go to a press fit BB?

Hamplanet - 12/18/12 - 2:05pm

@jeff No, that would be physically impossible

Post a comment:

Comment sections can be a beautiful source of knowledge, conversation and comedy. They can also get pretty ugly, which is why we've updated our Comments Policy. If your comment isn't showing up or suddenly disappears, you might want to check it out.