Home > Bike Types > Cyclocross

Stan’s NoTubes Adds 11-Speed Road 12×142 Thru Axle Upgrade Option

7 Comments
Support us! Bikerumor may earn a small commission from affiliate links in this article. Learn More

stans no tubes road 11-speed 12x142 thru axle option upgrade

Got a set of Stan’s 3.30RD or 3.30RDTi disc hubs/wheels you need to upgrade to 12x142mm thru axle? No problem, this new part is just $35 and does just that. It’s not for the mountain bike hubs and won’t work with Campagnolo freehub bodies or XD drivers, though. So, Shimano/SRAM 11-speed road or cyclocross.

The kit contains the axle and two end caps as shown, available now on their website. Check the install video below for fun…

Subscribe
Notify of
guest

This site uses Akismet to reduce spam. Learn how your comment data is processed.

7 Comments
Oldest
Newest Most Voted
Inline Feedbacks
View all comments
JBikes
JBikes
9 years ago

I don’t blame them for making it an option given it was cheap to do, but thru axles on the rear of road bikes are not required.
Increased suspension sub-frame stiffness is the only reason to go to rear thru axle. This isn’t needed on a rigid road bike frame.

Now, front thru axles. YES!

Gravel Bikes...
Gravel Bikes...
9 years ago

Saw this at Dirt Demo on the Litespeed T5g and T5d.

Matt
Matt
9 years ago

@JBikes
Disagree

Thru-axles on road are useful because they can help to assure proper alignment of the rotor upon placement and no slippage from that point. Same can’t be said of QR.

Also, the added stiffness could lead to even lighter framesets as the wheel becomes a member of the frame, and not just an attachment.

JBikes
JBikes
9 years ago

@ Matt,
I fully disagree. Side to side rotor alignment is achieve by locating the dropouts against the hub. QR does this just fine. Vertical alignment is not technically needed although easily achieved with a QR nonetheless.

Thru axles increase stiffness laterally and in torsion on suspension subframes that are often comprised of many individual parts linked with pivots – this problem largely doesn’t exist on road frames and in the loads they see.

Also road frame can actually benefit from a decrease in lateral stiffness at the dropouts as it acts as “suspension” against mid-corner bumps. Stiffness in relation to power transmission is largely unaffected by more rigidly constraining the two dropouts together as drive-side chain stays make the largest effect. BB stiffness is largely affected by the down tube design.

I won’t say great bikes wont be made with them. But from a design standpoint, I personally do not think rear thru axles achieve much on a road bike.

JBikes
JBikes
9 years ago

There is nothing inherently different in how a QR locates a wheel compared to a thru axle, assuming the QR hub is bottomed into the dropout. Draw it out or take both apart and you’ll see.

Kernel Flickitov
Kernel Flickitov
9 years ago

Great! But too bad Stan’s No Tubes hasn’t a clue how to build wheels properly.

Brad
Brad
9 years ago

I’m looking forward to rear thru axles on road bikes as it means I’ll have road wheels and 29er mtb wheels that are interchangeable.

Subscribe Now

Sign up to receive BikeRumor content direct to your inbox.

Subscribe Now

Sign up to receive BikeRumor content direct to your inbox.